> Subject: Removal of headboard in guest cabin > > We would like to reupholster the head board in the guest cabin but have not found a way to remove it from its present location. Firm pressure behind headboard yields nothing. There are no fasteners on engine room bulkhead plus at least 12” of the headboard is above level of helm sole. Does one have to disassemble the area under the nav station? Suggestions? > Thanks > Lee > Encore, NT37FB-190 > Jamestown, RI > > <IMG_2869.JPG> > > Sent from my iPhone

Look closely at the seams on the fabric of the headboard. I think there are small holes that would allow access to screws holding the headboard on. Likely square head, per typical Nordic Tug protocol. They are tough to see. Paul mv New Freedom Nordic Tug 37-187 > On Aug 16, 2025, at 8:14 AM, Lee Tuthill via Sentoa <sentoa@lists.sentoa.org> wrote: > >  > >> Subject: Removal of headboard in guest cabin >> >> We would like to reupholster the head board in the guest cabin but have not found a way to remove it from its present location. Firm pressure behind headboard yields nothing. There are no fasteners on engine room bulkhead plus at least 12” of the headboard is above level of helm sole. Does one have to disassemble the area under the nav station? Suggestions? >> Thanks >> Lee >> Encore, NT37FB-190 >> Jamestown, RI >> >> <IMG_2869.JPG> >> >> Sent from my iPhone > _______________________________________________ > Sentoa mailing list -- sentoa@lists.sentoa.org > To unsubscribe send an email to sentoa-leave@lists.sentoa.org